Adding BAP/Tremor dual exhaust/hangers and bumper caps

[mario_jr]

Would it be possible to add in all hangers and exhaust to make a non BAP/Tremor trim have the OEM dual rear exhaust. I was told I need the bumper caps with the two sensor mounts. I haven't been able to find any part breakdowns and part numbers online.

Sponsored

 

[diambo4life]

Obviously you haven't searched extensively, no offense. @rugedraw did this and others who have as well. Check out his thread.

 

[mario_jr]

Obviously you haven't searched extensively, no offense. @rugedraw did this and others who have as well. Check out his thread.

No offence taken I saw his post swapping over just the caps but not the whole hitch section along with oem hangers. I also noticed that he had to modify the sensor mounts for them to point in the right direction. I wanted to go completely OEM.

 

[SumGuy]

No offence taken I saw his post swapping over just the caps but not the whole hitch section along with oem hangers. I also noticed that he had to modify the sensor mounts for them to point in the right direction. I wanted to go completely OEM.

Good man. I too am an oem purist, whenever possible.

 

[dolsen]

You’ve got some reading to do

https://www.f150gen14.com/forum/thr...-rear-bumper-for-the-tremor-rear-bumper.6837/

I’ve purchased all of the parts, just waiting for the last few to come in

Sponsored