Str8Shooter
Well-known member
- Thread starter
- #1
Received a Trailer Brake System Fault message for the 1st time today immediately after starting the truck at 3007 miles (I snapped the below picture as soon as I saw it). Never had a trailer connected since I have owned the truck. Happened 3 times in a row and even saw it again after a short test drive. The fault message eventually went away after a couple times driving it, but there is a related code stored on the truck. According to my BlueDriver OBD2 Code Scanner I have 1 Anti-Lock Brake Module code U0253-00 - which is noted as a confirmed status of Lost Communication with Accessory Protocol Interface Module (No Sub Type Information). For MIL Status for Anti-Lock Brake Module code U0253-00 it states the fault cleared at 3014 miles.
I was also surprised to find another code stored on the truck and I am not sure if it is related. The other code is C1001-01. According to my code scanner it states that there was a confirmed status of a Vision System Camera General Electrical Failure. The reason why I am surprised to see this code is because I never noticed any camera problems. Worth mentioning is that this MIL Status for Vision System Camera General Electrical Failure code C1001-01 cleared at 878 miles.
Questions I have are:
1. Should I worry about taking the truck to the dealer since the codes cleared on their own? What will a dealer do when they see codes magically cleared on the MIL Status? Am I going to be wasting my time with the dealer saying everything works fine?....because according to the system, it now shows all the codes cleared on there own.
2. Anyone have these issues?
3. Are there related TSB's?
I was also surprised to find another code stored on the truck and I am not sure if it is related. The other code is C1001-01. According to my code scanner it states that there was a confirmed status of a Vision System Camera General Electrical Failure. The reason why I am surprised to see this code is because I never noticed any camera problems. Worth mentioning is that this MIL Status for Vision System Camera General Electrical Failure code C1001-01 cleared at 878 miles.
Questions I have are:
1. Should I worry about taking the truck to the dealer since the codes cleared on their own? What will a dealer do when they see codes magically cleared on the MIL Status? Am I going to be wasting my time with the dealer saying everything works fine?....because according to the system, it now shows all the codes cleared on there own.
2. Anyone have these issues?
3. Are there related TSB's?
Sponsored
Last edited: