hitchhiker
Well-known member
- Joined
- May 19, 2021
- Threads
- 4
- Messages
- 87
- Reaction score
- 142
- Location
- Maine, USA
- Vehicles
- 2022 F-150, 1965 F-100
- Occupation
- Software Engineer
- Thread starter
- #1
This is the steering column used by @dolsen in his Lariat 501A to 502A conversion. I purchased it from him, then fell asleep at the wheel and totaled my Lariat before I got around to doing the install. I've replaced the Lariat with a Platinum, so I no longer need this upgrade.
Here is @dolsen's description from his original for sale thread.
Here is @dolsen's description from his original for sale thread.
Asking $500/OBO. Photos below.I have for sale a powered steering column w/out active steering, the motor adjustment controls, wiring harness from steering column motors to a-pillar connectors, and and the powered steering column shroud. In my Lariat mid, all of the wires were populated from the DSM to the A-pillar connectors so I simply pinned them in there. Depending on your truck, you may have to run wiring all the way to the DSM. There is about 300 miles on this steering column, I bought it new
NOTE: Be advised, I DID cut the terminals off, I was limited on time and I, for some weird reason, have a very hard time depinning small terminals. I am about 85% certain there is still enough wire left to re-terminate and reconnect, but I will not make any promises, you may have to add length to the wiring. I will provide the correct terminals and my wiring diagram that I made specifically for this harness.
Sponsored