Asssistance clearing B1578:78 code in ipma.

[PFXLT]

I have the same error and for more than a month. Jesse did help me too to set up my IPMA. All codes gone after his programming and only this one stays.

NOte: I havent done the 360 calibration yet! Same weather not allowing.

But I did see there is a TSB for Mach-E owners for the same fault code, which list number of procedures to be performed via FDRS.

Were you able to get it solved OP?

I got a new fdrs subscription to help out a neighbor and did some more updates on my truck and at some point the dtc cleared itself. I think one of the updates was another IPMA update and that’s prolly what cleared it.

Sponsored

 

["Steve"]

^after reading that, i went ahead and reupped my license this week. module update alone did not fix the dtc for me.

ended up getting it resolved thanks to jesse's help. had to reset the learned values on ipma, and then redo alignment procedures. dtc gone. woot.