Yes, you are correct on the inlet and outlet. I think there will be a bit more involved with swapping the muffler as the pipe starts to bend up over the rear axle almost immediately at the muffler outlet.
I took my original exhaust off and put on the Borla S-Type catback system with dual rear...
Yes. I took the exhaust off in two parts with no cutting involved. I had the front of the truck on ramps and had to use my floor jack with a couple bricks to lift the body up a bit to get the tailpipe over the rear axle. Wasn't all that bad.
I just went and measured my stock exhaust that I took off on Sunday. The inlet for the muffler is 2 3/4 inch O.D. and the outlet side is 3 inch I.D.
The first picture is inlet. Second is the outlet side measured at the end of the tailpipe. Third pic is of the muffler outlet.
Hope this helps...
Thanks! I can't wait to get all of these boxes of add ons out of the house and on the truck where they belong. I have the short trim parts on the way to replace the crazy long ones on the front side of the rear wheel well too. One package that won't have dust on it 🤣
I got to test drive and look over the truck today! I didn't take pictures due to the dealership not cleaning the transportation grime off of it yet. Everything inside and under the truck was looking good and fitment was great. I want to check out the paint again once it is clean. Other than...
I haven't driven a truck in 16 years. That truck was 21 years old at that time. Do you guys have any advice or things I should look out for when i get my truck?