Think I got burned on Trailer TPMS Monitor with Camera and TPMS

[rxsamg]

I truly feel that all I need is the module and the harness to connect the module. My truck seems to be outfitted approximately on the truck side. See my three attached pictures.

Thanks so much for everyone's input and the additional thread(s).

Looks that way to me!
Just purchase one of the TPMS only kits (only difference between Pro Trailer Backup & non Pro Trailer backup versions is an additional port in the harness to connect your YAW sensor IF you were using that for Pro Trailer Backup Assist. IF you are using the stickers, either version is fine)

Sponsored

 

[hokieinidaho]

I got encouraging news from 1 dealer today, referring me to 2 gentlemen at another dealer's parts department that have done this before. I'll post back upon my findings after I call them.

 

[Buyer2021]

I truly feel that all I need is the module and the harness to connect the module.

Perhaps true IF the sensors you already have are the correct frequency and protocol to communicate with the trailer receiver module.

Do you know if the sensors you have send temperature data (the trailer TPMS kit sensors do)?

Good Luck, please keep us posted!

 

[Camshaft]

I am not sure, I just went to Discount and had them install 315 MHZ TPMS. That was my only requirement.

 

[Camshaft]

Interesting. Is this OEM or 3rd party?
Would still need to deal with the rear-end wire-harness deficit?

My pictures are OEM build out on my truck from the factory.

 

[Buyer2021]

I am not sure, I just went to Discount and had them install 315 MHZ TPMS. That was my only requirement.

You might get lucky and those communicate with the Ford trailer TPMS receiver module OK.

But if you install the module, confirm you have all the wires in place, and it still doesn't work .... then 99.9% likely it's a sensor compatibility issue (and that's my suspicion of where you'll end up).

Sponsored