pelon222
Well-known member
If you don’t have a back up saved from your original you would have to change each line individually to match your original as built
Sponsored
I believe it is to get every thing working as original from the factory and then start over one step at a time.But why pull the Sirius acm if I’m loading the defaults anyway from forscan?
With the link I provided, I have read there is a way to import the data from Fords site into FORScan?If you don’t have a back up saved from your original you would have to change each line individually to match your original as built
So I’m stuck at loading screen, I called xm udated vin.
Thoughts?
Open been drivign around for about 40 minutes no changeDoes your FM/AM radio work? Did you connect an XM antenna? Are you in a garage or out in the open when it is loading?
You gave them the radio ID not the vin correct?Open been drivign around for about 40 minutes no change
Rebooted unit no change
Spoke to XM updated VIN no change
Resent signal no change
FM AM No problems.
I have the OEM antenna but if antenna wasn't detected should say no antenna no?
I have the oem antenna on the dash which should work fine.
Gave them the radio ID with my UPDATED VIN.You gave them the radio ID not the vin correct?
Does your FM/AM radio work? Did you connect an XM antenna? Are you in a garage or out in the open when it is loading?
Mine said this until I connected the antenna wire to the back of the unit and then it said antenna problem because I had not installed the roof antenna yet. You did connect the antenna to the back of the radio correct? Just trying to cover everything.So I’m stuck at loading screen, I called xm udated vin.
Thoughts?
I would reboot the radio, hold down power and right seek until it reboots.Gave them the radio ID with my UPDATED VIN.
Correct Radio ID
Did that a few times...I would reboot the radio, hold down power and right seek until it reboots.