Headlight correction following level

[Zyvin]

Ok thanks everyone…I apparently don’t know how to find it in the online manual smh. My bad.

lol, no worries, it’s in the service section and not the headlight section. This picture isn’t the best, but look down from the top of the headlight and you’ll see a white Phillips adjuster.

Sponsored

 

[Tizzzo]

Guys here’s a picture for reference. This is on an xlt 302a with quad led reflector headlights. You twist clockwise to bring the beam down. This is my buddies truck I adjusted, it’s leveled on 34s and I brought it down 4 full turns. Mine is leveled on 35s and brought it down 5 full turns.

 

[MountainBraveHeart7]

There is a philips screw for each side even for the auto adjusting lights.

How do you access this screw? Do you have to remove a bunch of things inside the hood to get to them? Thanks.

 

[Zengineer]

How do you access this screw? Do you have to remove a bunch of things inside the hood to get to them? Thanks.

You have to open the hood.

I'll assume you don't need the manual pages. The thread is about a year old by the way.

 

[MountainBraveHeart7]

You have to open the hood.

I'll assume you don't need the manual pages. The thread is about a year old by the way.

Thanks, I should have looked down the thread as their are photos. Figured it out. I did 3 clockwise turns after a 2 inch lift. Will have to see if it works tonight.

 

[MountainBraveHeart7]

Guys here’s a picture for reference. This is on an xlt 302a with quad led reflector headlights. You twist clockwise to bring the beam down. This is my buddies truck I adjusted, it’s leveled on 34s and I brought it down 4 full turns. Mine is leveled on 35s and brought it down 5 full turns.

Thanks much. This really helped.

 

[Tizzzo]

Thanks much. This really helped.

No problem!

 

[Zengineer]

Thanks, I should have looked down the thread as their are photos. Figured it out. I did 3 clockwise turns after a 2 inch lift. Will have to see if it works tonight.

I didn't level my truck but took the 1.25 inch spacers out if the rear of my 2020 and 2022. I think the aim was a little low from the factory and doing this brought it up to where I like it.

It's best (and easiest) to aim or check them them against a wall at night.

Sponsored