Anyone receive their truck yet since they removed the Bed Camera?

[bnadude]

I'm curious if the light above the bed where the camera is usually located still has the hole for the camera or if it's a solid light now? Also if the wiring harness is there to insert an aftermarket camera or not. thanks!

Sponsored

 

[GEN14OWNER]

DAMN! They removed the Bed Camera"?

WTF?!!

I was talking to a friend who bought pretty much the same truck as me, at about the same time back in 2021. He SOLD his and ordered a 2023 and is now regretting it.

It seems like they had all this tech DIALED IN 2021 and are now yanking it all because of "chip shortages"? REALLY?!!

IN 2023"??

By the time they get around to adding it all back you'll be paying 15% on your loan!

 

[SilverPigeon]

This is how it is:

 

[FTMS]

I believe that is different. I was wondering the same thing. I am hoping the wiring is there.

 

[SeaJay1983]

I hope the wiring harness is present and modules for features. I don't mind purchasing a new lamp and high quality camera.

 

[SeaJay1983]

@ Silver pigeon,

Have you pulled the light and verify wiring harness is present?

 

[FTMS]

I hope the wiring harness is present and modules for features. I don't mind purchasing a new lamp and high quality camera.

What camera are you looking at?

 

[SeaJay1983]

I was looking at the CSPL camera, but if the wiring harness isn't pre-installed, to me, it not worth the hassle of the running it.

 

[personalt]

I have a bed camera that I would sell as long I can figure out the forscan changes to enable 360 setup without. Could someone who got 360 camera but no bed camera post their VIN so I can see how the settings are differnt?

 

[FTMS]

Got my truck with bed camera delete. Pulled the light and found a bunch of extra wires in the connector not being used.

Has anyone found a complete part # for the light? All I have is a partial 13A613.

 

[SeaJay1983]

That's promising, we just need a part number for the brake light assembly.

 

[FTMS]

I have a light coming with camera that i believe is correct. Once i get it i will see if everything is correct and see if there are any other steps to get it working.

 

[FTMS]

Bed light should be here tomorrow, any reason to think i will mess something up by just plugging it in and see if it is really that easy. I am not holding my breath on that one though.

 

[troy12n]

I've seen several on the lots, it's a solid flat piece. Which for me, works better because I will be putting a topper on it and i'm afraid the camera would interfere with the fit of the topper

 

[FTMS]

I got the light but it did not come with the harness. If anyone has found the part # for the harness please let me know. I will look for one a little later.

Sponsored