winterfell1977
Member
- Thread starter
- #1
I’m selling my used Ford F150 Console Vault 2015-2020 Part # 1062-3D-FLA. I have it listed on eBay, but I’d happily sell it to someone on here to avoid the fees. We could transaction through Venmo.
Listing description from eBay.
This is a slightly used center console vault removed from my 2017 F150 XLT prior to trading in. The lock has been reset to 000. All the screws and bolts are included. It is the three digit combo lock and is not digital/electronic and does not have a key.
A KEEPER MG Gun Magnet for Autos, is also included. It has a Magnetic Quickdraw Holder for Rifle, Handgun, Shotgun, Pistol up to 35lbs. Screw fittings and holes are pre-drilled in the interior housing on the front of the vault (inside panel of console storage box closest to the shifter). I didn’t like the location of magnet where it was for my uses, so you might want to reposition to your preference. Also I usually keep the holster on the gun while in the vault and 35lbs. Was not quite strong enough so I’m ordering a 55lbs. for the new one.
On the console vault interior panels some paint was marred from the housing bolts. Probably unnecessary as it’s unseen and will happen on your install but I touched up those marks with truck Bed-liner paint (please see picture). Also touched up are the screw holes for the magnet.
I will print out installation instructions directly from Console Vaults website. You should check the model number to make sure it fits your truck, make sure to select three digit combo lock when you do so.
Listing description from eBay.
A KEEPER MG Gun Magnet for Autos, is also included. It has a Magnetic Quickdraw Holder for Rifle, Handgun, Shotgun, Pistol up to 35lbs. Screw fittings and holes are pre-drilled in the interior housing on the front of the vault (inside panel of console storage box closest to the shifter). I didn’t like the location of magnet where it was for my uses, so you might want to reposition to your preference. Also I usually keep the holster on the gun while in the vault and 35lbs. Was not quite strong enough so I’m ordering a 55lbs. for the new one.
On the console vault interior panels some paint was marred from the housing bolts. Probably unnecessary as it’s unseen and will happen on your install but I touched up those marks with truck Bed-liner paint (please see picture). Also touched up are the screw holes for the magnet.
I will print out installation instructions directly from Console Vaults website. You should check the model number to make sure it fits your truck, make sure to select three digit combo lock when you do so.
Sponsored