The WT-1004 terminals above were close but did not quite fit into the BCM connector, so ended up getting a 3 day pass for Ford service manuals to confirm what I needed.
C2280A (Bottom BCM Connector - passenger footwell)
Pin 15
Terminal Service P/N: EU2Z-14474-AB
Here's a schematic showing...
One more question for those that have done this, which wire on the 2 pin connector at the back of the SCCM is power and which is ground? Got everything installed today and just need to run the wiring later this week. The rest of the install was a piece of cake, thankful the steering wheel is so...
Does anyone have a part number or size for the terminal needed to connect to pin 15 on the C2280A BCM connector? Getting parts ordered for this and want to make sure I have everything on hand.
Anyone else run into issues purchasing the FDRS license? I tried twice, I get all the way to the end and once I submit the order it says something like "there is nothing in this order" and makes me start over. Realized it also put pending charges on my CC for those two orders, so hoping those...
Finally got it all done. Turned out awesome, well worth the wait in parts. I got lucky and received the cupholder assembly with light ring and LEDs for $27 shipped.
HVAC controls are plug and play, I just ordered a new opened box from eBay with the same options and it worked without issue. You can use forscan to turn off the temp display at the top of the 12 inch screen if you want. I added the media bin and glove box lights using a harness made by...
Loving all the pics so far! (Except @SlowPitchSoftball, that is rough ?)
Here’s a few more pics taken over the course of the last month, as well as a sound clip of my new exhaust I installed today. Exhaust is a Borla S type catback.
So far I have also installed a Bakflip tonneau, wheel well...
I was back and forth between 3-4 different colors, lots of good choices! Settled on Iconic Silver as silver is good at hiding dirt and minor scratches and swirl marks.
Truck is quite dirty here but you can barely tell.
Did this work immediately for you or was there any delay before the temps disappeared?
I also had a 4 for MAC Disabled • SBT Off • DFC Disabled • CAS Disabled which I replaced with a 0, but so far temps are still showing.
I didn't disconnect the battery but might try that if no change after a...
Thanks, that’s exactly the info I am looking for. I love the deep tone in all the sound clips I’ve heard but was worried about drone. I think I’m going to pull the trigger on the Borla.
Headed down to Granger and got mine picked up today! First impressions are all good, cab is extremely quiet and even with max tow it rides very nice. The 5.0 seems to have plenty of power and I love the copilot assist. I have the same issue as @kb2755 was seeing where both the front and rear...
Appreciate the feedback! Going to look into both of those more. I still keep going back to the Borla S Type but trying to watch as many videos as possible before I decide.
Wondering if anyone here has either of the 3" Borla Cat-Back systems on their 5.0? Looking for opinions on sound outside of Youtube videos, and wondering if these have any drone. From what I have seen, the 5.0 needs a resonator to avoid drone or to avoid hearing the cylinder deactivation.
I've...
I’ve spent hours watching exhaust clips on YouTube and I’m torn between the mbrp 3” catback that includes both the resonator or the bypass pipe, or the borla s type. The mbrp sounds a little quieter in most videos, but I’ve come across reports of drone. The borla sounds louder on a cold start...
Haven't heard confirmation from my dealer, but just checked the tracker again and it shows delivered now!
I know Granger is swamped right now but hoping I can get down there this week to pick it up!