Search results

ok I will drive it tomorrow and see if it goes away thanks so much. I am charging the battery right now to see if that helps anything

I just did some updates in FDRS including the BCM and now I have a check brake system message and also a 12v battery state of charge error message that come up on my display when I start the vehicle. This didn't happen before the update. The ABS module error is related to inadequate voltage...

I went on a 2 hour drive and when I was going there it seemed to clear up. At some point my collision disabled light came on but the error when I put it in reverse went away. Also my lights weren't automatically switching between high and low beam like they normally do (glare free lighting I...

No that isn’t it. Are your sensors dirty?

My truck needed the IPMA unlearned and then recalibrated. I calibrated the lane keeping but whenever I back up now I get an alert about reverse backup assist. I tried unlearning again and recalibrating the lane keep but it didn’t help. I didn’t recalibrate the 360 camera yet maybe could that...

Blue cruise doesn't really add anything except irritating eye detection even when not on blue cruise roads. Other than that it is the same system but has GPS so that it knows in advance if a bend is too sharp for it to confidently make and shuts off in advance of going into that bend. I turned...

So this is weird but I was driving and the mirror in my 2021 F150 popped right out....it was still attached by the wires but the clips that hold it in place cracked and broke! It's a 2021 but out of warranty. I called the dealer and the new glass part is almost $500 Canadian! Now this is a...

PM sent

yes please

Nope still same error even with that

I will try after dinner and then report back

ok will try that thank so much

well I did the follow the prompts ok the first time, then the second time I did as well but it wouldn't work and gave that error, then I tried resetting it again with the ignition on and the car running so that I could do the whole thing without unplugging the computer from power and it gave the...

My front camera has a fault that is breaking a bunch of features in my truck. There was a Ford document that said that the error I had the first thing to try is to reset the IPMA module and recalibrate it. I tried to do that and it reset fine, then I was going to calibrate it and I realized...

Just to follow up with all of this, the media hub that was working and then seemed to stop working has now been working again and is working fine. So that issue seems to be resolved. It may have been getting shut off by the BMS. There is however the problem of the network not working, I can...

so I am wondering if this is a battery issue. I replaced the Media Hub. It was working when I put it in. Then it stopped working. Also I notice that the TCU is intermittently working (sometimes it won't let me access connected services, sometimes it will, it was giving some errors at some...

Seemed high. Any idea what voltage on that line is supposed to be?

Thanks for the help hopefully this is supposed to be a 16 volt line

I am getting 12 volts between illumination and ground with the car off and 14 with the car on. I am getting 16 volts between media power and ground no matter if the car is on or off.

Oh ok you mentioned a fuse previously. I am just going home to test the 12v line to see if it’s powered. I hope it is I know the apim is expensive