Correct me if I’m wrong as I don’t know much about this stuff but it seems tapping a fuse and pinning a BCM connector would be vastly different. I wouldn’t mind tapping and fuse but I wouldn’t go pinning a BCM connector in any spot
as a matter of fact I asked about pins #24-25 as they were open and did not involve depinning #23 and he explicit said probably not a good idea as we don’t know what it powers and it could be catastrophic. So I went ahead and depinned #23 and used that one. No issues so far with taking that one out
Pin #4 is referring to the BCM connector c2280c. It is not used at all in the Upfitter set up. It was just something I noticed. C2280c is the top larger one in the BCM. Blue illumination is received through the SCCM. It’s the connector that has red arrow pointing to it And orange illumation...
yupboosted stated it is not used and to go ahead and depin that pin in #23. Tape it up. And use the one on the harness, worked perfect. Without Any issues. Harness is working flawless. You have to remove the red safety and I stuck a little toothpick in the front of the connector to release the...
Received a response from boosted. Stated that it’s probably an extra wire and the circuit is not used. So go ahead and depin and insert the harness pin. To which I did
Also. In the diagram 1 and 2 is open. 3 and 4 is taken. On my connector. The only one taken is 3. 4is open. You can see the small numbers in the corner on this picture. The connector I’m on has the same 36 pins so I’m not sure what’s going on
The diagram also shows 28-29-30 is taken. I only have 28-30 taken. 29 is open as shown in the picture above. 28=large red/white. 29 open 30=small green
Okay here are some pictures.
Here are some pictures. Next to the red and white inside the connector shows the number 28. Right above this is 18. Has to be as it’s below 28. According to the diagram that’s on the instructions 20 then is open. 21-22 is taken. Which is shown on the picture. But...
done almost. Just cannot for the life of me find where he wants the single green pin at. I looked at the connector that’s on the instructions and either it’s pinned different or I can’t read it at all. Not sure where it goes. I reached out to him to figure it out. Im pretty sure this is the...
my ditch lights actually route through the passenger fire wall which was an absolute PAIN to get through. I had to take a wire fisher and by some luck of god went up through the passenger floor board and somehow popped out of 1 inch wide hole at the top of the firewall. Not a single chance in...