The wiring is not bad at all, just run one to the ground and another over to the BCM and that’s about it. Everything else is plug and play with some forscan programming.
Im not entirly sure about that, I would say as long as you have the front camera in the windshield and then add the required hardware you should be fine.
I just used whatever wire i had in a 22 guage but the pins for the ipma can be found here, https://www.fordpartsgiant.com/parts/ford-terminal_du2z-14474-ca.html
they are single only so you will need 4
and yes you can run directly from the CCM right to the IPMA
i appreciate all the help, after calibration it worked great. Stop and go is definitely something the get used to when you've never had the option before.
If you pm me i can definitely walk you through it, i had a ton of help from jesse and superfordman. the install is still fresh so i can help you out the most i can.
I actually do have the speed sign recognition, I just wasn’t sure because at one point it actually showed cruise control and under that ACC and then under that IACC as options to select
i took the ccm and brought it into the cab and pretty much hooked it up pin to pin to rule out the harness being wrong and it was wrong, the ipma regocnizes the ccm and will throw a dtc when ground is disconnected but i am still unable to see the ccm under modules in forscan, any suggestions?