Not keen on the plastic caps that come with the methods. Used plastic tube caps and had silicon graphics made up to go with the bronze and Velocity blue of thetruck. Got a matching steering wheel silicon made.
Have 30mm spacers and studs protrude slightly. Inside face of the 2021 18" sport wheels are not flat on inside mating surface ( probably to reduce risk of sticking between surfaces). These indents are enough to clear studs without any problems. Aftermarket wheels may be different.
Interesting to see you say they are the same as rear. I know they are the same physical shape, but the rears come as a number of different part numbers and prefix letters. Do you know if they are all the same internally and would work being swapped front to back. Or would they not be recognised...
Since posting the above pin out. I have acquired the 700+ page wiring Bible for the 2021. This may help more. On my sketch the pin numbering is different to that below. Using below the turn signal is No 2 for both LH and RH.
Your wiring appears much the same as mine, as it should be being same the same model.
Having not had any response from asking the same information on a few forums. Ended up pinning out what I could.
Left hand headlamp female connector.
.
1. Blue (large) 12v switched on low beam and high...
Update: Slightly more involved as have to remove the 4 white plastic clips that attach the bottom valance to the front, once these have been removed the full front plastic part can be unclipped by pulling forward together with center section. The center plastic will then unclip and can be r...
Took my bumper apart for other reasons. Did not do swap but the solid infill panel is identical fittings. Can be done with bumper in place. The small plastic panels either side will need taking off first and then the center. Easier and less chance of damage to paintwork if can be pushed from...
2021 Lariat. Looking for pin out information for Dynamic LED Headlight. Have seen some schematic diagrams showing some of the wiring. But nothing showing pin connector terminal wiring.
The surround comes as one moulded piece.
I add extra 3M double sided tape to it before installing as insurance. Adding extra if needed later is awkward to do without complete disassembly.
The steering wheel surround is one of the few parts that has an option to buy a real Carbon fiber surround...