Search results

When I did mine, I spent a good bit of time looking at the harness routing before unhooking anything. I then took a couple plugs apart, removed some of the harness, and started putting the new harness in its place. Then removed a little more of the harness and so on. Yes, I believe every plug...

Water will come in around the pano roof, at the sides where the two glass panels meet. You might want to have someone inside the truck with the pano shade open, and then someone on the outside with a hose moving to various spots around the pano roof. You should be able to see water coming in and...

I lose MyView settings all the time, maybe once every week or two.

Derrick was great to work with. I asked questions before the purchase and never got the impression that I was being a pain in the butt.

RIP @labjr1

I'll have to give this a try. Thanks.

I've never noticed this. I've had 1.4 for quite a while, but may be I am too impatient to wait for it to tell me it's clear to pass. How does it notify you when it's clear to pass?

That's the more aggressive side. Here is the other side. A bit hard to see.

You're right. I tried it again and this time got the OTA that I had received a couple days ago.

You're in a lot colder weather than I am, so that could have something to do with it. But 5 minutes seems very long. My high idle is only for about 20 seconds, and then goes down to something like 800.

Same with mine. First time to the page and it said "your vehicle does not...". Refreshed the page and it showed the 90 days notice. My sync screen 2 days ago showed (for the first time) an update was just applied.

Turning this on for my '22 Platinum was the first Forscan update I did. Not sure if this is the problem, but you might take a look at this value in Forscan. https://www.f150gen14.com/forum/threads/22-f150-plat-change-front-cam-activation.14621/post-299428

I was on my way back from Orlando, almost to the Texas border, about 2am. Traffic came to a complete stop due to a wreck miles ahead. I got out and started talking to someone. I walked back tried to open the door, tapped on the window to get my wife to unlock the door. The window cracked open an...

I got lucky and a dealer near me replaced the one year old battery with another H6. I left it overnight and picked up later the second day. I think they said they had to charge it, and then let it sit to watch the state of charge. Unfortunately, it's a small thing and I think each service...

Did you leave the from struts at full extension, or did you take some turns out of it? I took 10 turns out and ended up with about 1 inch rake, which was my target, and this resulted in a very nice ride.

Which locks did you get?

I don't have a V8, so I don't know. I suggest doing the same thing. Look at the current value, and the options that are enabled. Then look at which value enables the MCSEC and leaves the others the same.

You'll need to review the Forscan sheets. Livinitup's Forscan worksheets For 7D0-01-03, the first character has 16 possibilities, 0, 1, 2,3,4,5,6,7,8,9,A,B,C,D,E,F. Each value tells whether the BA, RBA, EMCS, and ALSS are enabled. You are trying to enable EMCS. So, you will need to see what...

First three characters tell you the module. 7D0 = APIM 6F0 = BCMC From Livniup's spreadsheet -

This is what I had to change on my '22 Platinum 7D0-01-03 X*** **** **** (X bit) from 5 to 7 depending on vehicle options 6F0-02-02 **** *X** **** (X bit 5 (EB) or 7 (PB)