Power-Up 4.3.2

[JFR0317]

My truck downloaded Power-Up 4.3.2 yesterday afternoon, but after scheduling a time to install, it has repeatedly failed to install because "certain preconditions were not met." I had the battery connected to a charger overnight and scheduled another installation attempt this morning, but that too failed to install. I have completed all updates available in FDRS and am at the equivalent of 4.2.4.

My truck's VIN is 1FTFW1ED8MFA77616.

Sponsored

 

[Jesse-Infotainment]

It’s a IPC(cluster) update. I’ll look and see what is up.

 

[Jesse-Infotainment]

I cant see your connected vehicle status. Check your connectivity settings and make sure they are all on.

 

[JFR0317]

Everything shows as on.

 

[Jesse-Infotainment]

Ok.. It is showing now. All I see is an Error code of 204. No idea what that means.

Make sure the E-Brake is on? I thought it was supposed to inform you of the precondition that is not met.

 

[kb2755]

Ok.. It is showing now. All I see is an Error code of 204. No idea what that means.

Make sure the E-Brake is on? I thought it was supposed to inform you of the precondition that is not met.

Maybe try turning the lights off

 

[JFR0317]

Yes, the e-brake is on. The only one of the listed preconditions that I might not have met would be state of charge of the 12v battery, but my charger showed 100% charge right before I disconnected it prior to trying the update this morning. I disconnected it so that I could close the hood, which is another one of the listed preconditions. It did not specify which preconditions had not been met after not being able to complete the installation.

 

[JFR0317]

Light were turned off.

 

[JFR0317]

@Jesse-Infotainment Thanks for checking, Jesse.

 

[Ford4Ever]

Ok.. It is showing now. All I see is an Error code of 204. No idea what that means.

Make sure the E-Brake is on? I thought it was supposed to inform you of the precondition that is not met.

I see that error code all the time when I perform an "inspect" on the owner site.
{errorDescription: "No Qualified Alerts Found", statusCode: "204"}
Far as I know it means that there are no updates pending.

 

[Jesse-Infotainment]

I see that error code all the time when I perform an "inspect" on the owner site.
{errorDescription: "No Qualified Alerts Found", statusCode: "204"}
Far as I know it means that there are no updates pending.

Interesting. Thank you!

 

[speedracercjr]

It’s a IPC(cluster) update. I’ll look and see what is up.

Maybe they are returning the turn signals to their middle position instead of the far corners of the dash.

 

[Orlando150]

Maybe this?

 

[rugedraw]

Try resetting the BMS on your truck. I see it has failed over and over again. I wish PTA would provide more details on which condition is not being met.

 

[zacko11288]

I wonder if this is adding the additional functionality/icons needed for BC 1.2?

Sponsored